Today,Jinyi brings you the relevant content of the slitting machine. This article will mainly introduce the knowledge of the maintenance and operation procedures of the slitting machine. I hope it will be helpful to you. Next, let’s take a look with Jinyi.
Define the slitting machine:
Slitting machine is a kind of mechanical equipment that cuts wide paper, mica tape or film into multiple narrow materials. It is often used in paper making machinery, wire and cable mica tape and printing and packaging machinery.
Maintenance of slitting machine:
Before use, the main components of the automatic slitting machine should be inspected and lubricated; when inspecting and disassembling the automatic slitting machine, it is strictly forbidden to use inappropriate tools and unscientific operation methods; divide the slitting machine every two weeks. The cutting machine should be thoroughly cleaned and inspected; if the automatic slitting machine is not used for a long time, all bright surfaces must be wiped clean, coated with anti-rust oil, and covered with a plastic cover to cover the whole machine.
If the automatic slitting machine is out of use for more than 3 months, the anti-rust oil should be covered with moisture-proof paper; after the work is completed, carefully clean the equipment, wipe the exposed friction surface clean, and add lubricating oil. Daily maintenance, to do a good job in the daily maintenance and maintenance of the slitting machine, you must do the following points.
First, the electrical parts of the slitting machine should be cleaned and inspected regularly;
Second, the slitting machine should use high-quality slitting knives and cross-cutting knives;
Third, the daily maintenance of the slitting machine should be in place. The criterion is that it is smooth, clean, and cleaned (no dust and debris) in place to ensure that the sliding parts of the equipment are in good condition;
Fourth, it is maintenance work, and regular and irregular inspections of the rotating parts of the slitting machine should be stopped.
Slitting machine operation process:
1. The operator must be trained before taking up the job, and must be familiar with the use of different slitting machines! Equipment performance and general maintenance methods. Persons who are not of this type of work are not allowed to operate at will;
2. Do a good job of labor protection before starting the machine, prepare some auxiliary tools and materials for the operation of the slitting machine (knife adjustment tools, cartons, paper tubes, paper cutters, tapes, etc.) ;
3. Make sure that the slitting machine is in a safe state, turn on the electrical switch, check whether the circuit is lack of phase and whether the gas circuit is smooth, test the machine, and check whether the electrical, pneumatic, and mechanical equipment are operating normally. Whether the mechanical protection facilities are perfect. During operation, prevent crushing, scratching or bringing into rotating gears, chains, rollers, etc.;
4. Knife adjustment: adjust the exact knife distance according to the job requirements, and pay attention to the direction of the knife edge. If necessary, remove the bottom knife and re-arrange the knife. If the knife has a gap or is not sharp, it must be repaired and replaced;
5. Investigate the connection of the static elimination facility of the slitter and the ground wire of the machine to ensure that the static electricity of the material is eliminated during operation. Lay waste paper under the machine to prevent dust adsorption;
Well, the above is all about the slitting machine. Through the introduction of this article, I believe that everyone knows that the maintenance of the slitting machine is a regular cleaning and inspection of the electrical parts. It is realized by using high-quality vertical and horizontal cutting knives and daily maintenance. The general steps of the operation process of the machine, if you want to get more content, please pay attention to Jinyi, we will see you in the next issue.
Post time: May-24-2022